Did I just brick my SAS drive?
I was trying to make a pool with the other 5 drives and this one kept giving errors. As a completer beginner I turned to gpt…
What can I do? Is that drive bricked for good?
Don’t clown on me, I understand my mistake in running shell scripts from Ai…
EMPTY DRIVES NO DATA
The initial error was:
Edit: sde and SDA are the same drive, name just changed for some reason And also I know it was 100% my fault and preventable 😞
**Edit: ** from LM22, output of sudo sg_format -vv /dev/sda
BIG EDIT:
For people that can help (btw, thx a lot), some more relevant info:
Exact drive model: SEAGATE ST4000NM0023 XMGG
HBA model and firmware: lspci | grep -i raid 00:17.0 RAID bus controller: Intel Corporation SATA Controller [RAID mode] Its an LSI card Bought it here
Kernel version / distro: I was using Truenas when I formatted it. Now trouble shooting on other PC got (6.8.0-38-generic), Linux Mint 22
Whether the controller supports DIF/DIX (T10 PI): output of lspci -vv
Whether other identical drives still work in the same slot/cable: yes all the other 5 drives worked when i set up a RAIDZ2 and a couple of them are exact same model of HDD
COMMANDS This is what I got for each command: verbatim output from
Thanks for all the help 😁
The drive got whipped and apparently you’re not supposed to wipe a SAS drive like a normal SATA one …
Oh, it was just sitting there and “got wiped”? Not because of a command you ran?
Sorry to be snarky but when asking for help you need to provide what you did, what error message you see now or what you expect to happen and what is actually happening. Also what OS you’re using would be helpful.
Presumably you should be able to get the drive back into a usable state - but I’m not familiar with SAS drives.
Mb, I meant I wiped the drive…
I am using Truenas CE