nieceandtows@programming.dev to 3DPrinting@lemmy.worldEnglish · 20 hours agoWhat is causing these layer lines? I'm assuming it has something to do with the curved part, as it starts around the same height as them. Is there a way I can avoid these?programming.devimagemessage-square9fedilinkarrow-up139arrow-down10
arrow-up139arrow-down1imageWhat is causing these layer lines? I'm assuming it has something to do with the curved part, as it starts around the same height as them. Is there a way I can avoid these?programming.devnieceandtows@programming.dev to 3DPrinting@lemmy.worldEnglish · 20 hours agomessage-square9fedilink
minus-squareBlue_Morpho@lemmy.worldlinkfedilinkEnglisharrow-up2·20 hours agoIncrease / decrease infill/wall overlap % seems like the best advice I found while googling. Imo printing on edge would fix it and make the print stronger but that could require changes to the model / printing with supports.
Increase / decrease infill/wall overlap % seems like the best advice I found while googling.
Imo printing on edge would fix it and make the print stronger but that could require changes to the model / printing with supports.