I put this in another reply, but I know not everyone will pop back into the thread so…
I completely agree with your approach and that’s what I would usually do. The print is probably off by 1%, which over these spans is 2mm. Massaging this print to fit isn’t really practical :(
That’s what a small set of files is for! You put in three boundary layers, use them!
I put this in another reply, but I know not everyone will pop back into the thread so…
I completely agree with your approach and that’s what I would usually do. The print is probably off by 1%, which over these spans is 2mm. Massaging this print to fit isn’t really practical :(