TinkerCAD has a low enough learning curve that it is successfully used to teach elementary school students how to model. I disagree with your “but it’s a complex program, so it can’t be easy to pick up.”
Something being inaccessible to the masses shouldn’t be a badge of pride. Make the basics relatively easy to learn, and design the complex elements in a way that builds on the knowledge used for whatever was needed to get to that point. If we want to increase usership of FOSS products, we need the barrier to entry to be at least on par with the commercial products, if not lower. In fact, dedicating a few dev cycles towards new user onboarding to walk people through sketches, extruding, etc. to make it as accessible as possible would make such a difference.
TinkerCAD has a low enough learning curve that it is successfully used to teach elementary school students how to model. I disagree with your “but it’s a complex program, so it can’t be easy to pick up.”
Something being inaccessible to the masses shouldn’t be a badge of pride. Make the basics relatively easy to learn, and design the complex elements in a way that builds on the knowledge used for whatever was needed to get to that point. If we want to increase usership of FOSS products, we need the barrier to entry to be at least on par with the commercial products, if not lower. In fact, dedicating a few dev cycles towards new user onboarding to walk people through sketches, extruding, etc. to make it as accessible as possible would make such a difference.