Oh, I’m a-doin’ it.
This part is actually slightly outside the “safe print zone” dashed lines on my build plate. I put down like half a can of hairspray on it right before the nozzle descended. Wish me luck.
Oh, I’m a-doin’ it.
This part is actually slightly outside the “safe print zone” dashed lines on my build plate. I put down like half a can of hairspray on it right before the nozzle descended. Wish me luck.
The first layer on top of infill is basically a giant bridge. So yes, your slicer’s strategy is to move the print head quite slowly. Usually the surface area isn’t very large, so it’s not a big deal. In this case, uh. Yeah.