MrQuallzin

Yup, changing out your extruder, even if to an identical one, changes the weight just enough to cause this. Input Shaping is indeed what you want to look for, it’ll be different depending on the printer. Some you have to adjust config files, some you can actually do in the slicer now.

I’d give OrcaSlicer a shot, it has some built-in tuning mechanisms

It’s an internet famous spider. Been a while since I’ve seen it! You’re one of today’s lucky 10,000 if this is your first visit from the seven-legged spider

As long as the borders are printing you should be golden. Not something you’d want to to often of course, depending on the printer, since you might strain the hardware at the extreme edges

I just got Easy!Appointments setup after being disappointed by cal.com. I don’t see any options for ics, but it does have CalDAV integrations (along with Google sync as well). I haven’t personally used the CalDAV integration so can’t speak to how mature it is. I’ve got my SMTP settings setup and emails go right out

I’d settle for the small lag with a humidity sensor. If you’re the type to run the shower for a minute before getting in, it should kick in in that time.

Could do a presence sensor or motion sensor pointed at the shower. Haven’t played with either, and you’d have to figure out water resistance.

It’s looking good! I need to start polishing mine up, going to use some of this as inspiration!

I used Claude to do my initial Homepage config, but I’m doing the dirty work getting in there and making it mine.