Cheers! Much obliged. Will definitely be adding ESD protection.
I based the USB power circuitry on a reference that assumes Micro-USB and I know that USB-C is really different when it comes to power. I’ll see that I put a resistor there, as you did.
The point about connecting up the redundant pins is also an interesting one, think I need to look into the PDF for the specific part I’m using to know what extra work is necessary, if it is necessary. 👍
OK, that reassures me.
I’ll get to swapping the caps for bigger ones though I do like the challenge of soldering them.
The spirally tracks/flourishes I added simply because of looks. No intentional RF stuff going on here. I have the track smoothing plugin installed and felt bad about not using it. Besides, the switch goes directly to ground here so having a bit of “cable salad” probably won’t do any harm, I could even draw a little Tux on the board if I were so inclined…
Thank you by the way!
Here is the entire right side
Companies are an awful trend.