nieceandtows@programming.dev to 3DPrinting@lemmy.worldEnglish · 2 days agoWhat is the problem here?programming.devimagemessage-square26fedilinkarrow-up137arrow-down10
arrow-up137arrow-down1imageWhat is the problem here?programming.devnieceandtows@programming.dev to 3DPrinting@lemmy.worldEnglish · 2 days agomessage-square26fedilink
minus-squareThePantser@sh.itjust.workslinkfedilinkEnglisharrow-up23arrow-down1·edit-22 days agoToo close, level the bed and increase the Z offset until the smoosh is right. Also since it looks like it’s in different places you should do a probe calibration to adjust for uneven surface.
minus-squareJoelk111@lemmy.worldlinkfedilinkEnglisharrow-up2·7 hours agoIn some places it’s too close, but in many places (like the top) it’s way too far away.
minus-squarespitfire@lemmy.worldlinkfedilinkEnglisharrow-up2·2 days agoAlso preheating and waiting before bed leveling helps. These beds are wobbly. I’ve put a glass bed on top of the factory one on my K1
Too close, level the bed and increase the Z offset until the smoosh is right.
Also since it looks like it’s in different places you should do a probe calibration to adjust for uneven surface.
In some places it’s too close, but in many places (like the top) it’s way too far away.
Also preheating and waiting before bed leveling helps. These beds are wobbly. I’ve put a glass bed on top of the factory one on my K1