I’m printing some Gridfinity bins for some drawers, and one of them needs to be quite tall to fulfill its purpose (18u, ~130mm). I took a shortcut and generated one from this generator using the default wall thickness and printed using Prusament PLA. This resulted in the walls falling in on itself, and my second failed print.
In hindsight, considering the wall thickness of 0.95 mm, this seems pretty obvious to me now. I want to give it a second go, but beef up the wall thickness and make sure there’s some proper infill between the outer walls to keep it stiff.
At the same time I don’t want to waste too much filament, so I want to hit a sweet spot of sufficiently thin walls and sufficiently low infill percentage, while avoiding another failed print.
Anyone have good experience with these kinds of prints that could give some input on a rough estimate for what I should aim for here?
I am using Adaptive Cubic infill by the way, but for no other reason than that has become my default infill pattern after some previous suggestions made here.
Good lord no. Don’t do that. That would be a waste of filament and also cause a host of other problems for you.
Determining how many walls and perimeters you might need for any print, depends on how much you intend to stuff in your bin and what size nozzle you are using.
Usually, I use a .60mm nozzle to print gridfinity parts. That way I can easily use 2 walls for perimeters. But if you don’t have a .60mm nozzle and only a .40mm, that’s fine too. I would just increase the number of perimeters to 3 and get about the same wall thickness. Using too many walls may cause problems with warping due to uneven cooling. Or if it’s a light duty bin, like one meant to hold small screws, 2 perimeters would work as well and be faster and cheaper to print.
For infill choices, adaptive cubic is just fine for the majority of gridfinity bins, since the majority for strength to be had in 3D prints comes from the top, bottom, and perimeters, (and this is why we increase those for get the strength). But if you need the extra strength, something like gyroid works well, (and you’re maxed out at 20% infill).
Just to be clear, it is the “hoping to use infill to get some support” that your response is aimed at, right? Out of curiosity, what kind of problems could I be looking at for this?
In the meantime, I’ve been printing some smaller bins of about half the height of my problem where I increased the wall thickness of the model from the default 0.95 mm to 2 mm, and used 3 perimeters, which resulted in fairly sturdy walls.
Looking at the same bin with 2 mm walls without infill, and 3 mm walls with infill, there is barely any difference in material usage.