Oh, I’m a-doin’ it.
This part is actually slightly outside the “safe print zone” dashed lines on my build plate. I put down like half a can of hairspray on it right before the nozzle descended. Wish me luck.
Oh, I’m a-doin’ it.
This part is actually slightly outside the “safe print zone” dashed lines on my build plate. I put down like half a can of hairspray on it right before the nozzle descended. Wish me luck.
It was being careful lol
Sound like so far, so good, keep us posted.
The first layer on top of infill is basically a giant bridge. So yes, your slicer’s strategy is to move the print head quite slowly. Usually the surface area isn’t very large, so it’s not a big deal. In this case, uh. Yeah.