Yes they are presented in the programmer wrong. The first thing in memory should have offset 0 and index 1
Yes they are presented in the programmer wrong. The first thing in memory should have offset 0 and index 1
Companies want profit but the people who run them want control. Sooner or later the companies will reconfigure themselves to benefit the bottom line.
If you need to not have a cable, the butane ones would be a better fit.
It’s 80$ and doesn’t include a battery. But the ifixit one does include a USB cable and a bevel tip (cone tips are bad)
So it’s more like $26 plus $4 for pine USB cable, plus $6-11 for a ts100 bevel tip. $41 vs $80
Pinecil is 26$ and has a screen.
I wished this morning existed way before it was out. I have been using it from day 1. I love it.
I refuse to buy anything without hall effect sticks. So that’s limiting enough.
There is nothing you can do to my body that I will find disrespectful.
I was never satisfied with home vacuum cleaners. At some point I needed a shop vac for sludge and I bought a kärcher Wd3. It’s big and loud but cost/effectiveness ratio is unreachable by any home vac.
Very creative, but doesn’t really work here.nothing relied on cloudstrike.
Your phone is bragging about supporting wifi6
It’s the raspberry pi of printers. It’s good for hobbyist and as a learning platform. its very cheap to get/mod and find parts.
But it’s not reliable enough for someone who wants printed parts. People who know 3d printing will underestimate the knowledge needed to use one of them.
Chuck the bed in the fridge for 1-2 mins
Lower layer height will make the steps smaller. In orca slicer you can use adaptive layer height to decrease layer height just on the top of the dome.
Choosing different printing orientation can be a solution.
It’s worth giving a try
Don’t they gender the eggs now? They just don’t hatch the male ones.
You want one?
She is right, using 0 index for physical stuff is stupid.