deleted by creator
deleted by creator
Hehe I was in global shipping IT, we had some ooooold Solaris systems that handled freight halting data flows. Windows Server 98 servers that handled data for very large shippers. Every daylight savings time change something would break.
I hate when the captcha starts at 1/10, so much so that I’ll usually just walk away if I can.
Had one of these uncles, he also featured a single good eye, the other damaged in a previous fireworks mishap. Didn’t stop him though, and the bad eye could see clear underwater he’d say.
In my opinion, it ends in nova and the transition from prog to nova with the y is just 🤌
deleted by creator
Ugh, thanks I hate it lol. You’ll have to pry FF from my cold dead cyber paws.
Mullvad, but I’m running into the same problem more and more.
Agreed, getting stuck in the captcha loop makes me unreasonably irritated lol. Hopefully, it gets resolved for you soon!
Interesting. I use ublock on Firefox and gpt daily. Haven’t had any login issues, also use multiple VPN addresses. I think the only verification I’ve had is the easy checkbox.
I don’t know the Bambu model, but I do have an ender 3 and a prusa mk4. The ender 3 out of the box doesn’t have an auto leveler, it is “dumb” and it assumes the level of the bed is correct (if you leveled it right it should be).
Other printers like the mk4 and I’m assuming the Bambu have auto levelers that sample the level of the plate over several points, and then remembers the height of these points. Because it remembers the heights, it can adjust for a bed that isn’t manually leveled, so there’s no need for knobs.
You can get this functionality for the ender with a bltouch. But you’ll have to enable it in the firmware and do some configuration and wiring. It’s not too hard.
I’m with you, but my landlord is not.